Replacing OIT
SyncroFlo, Inc.May 12, 1998
Roy,
Here are the Operator Interface Terminal (OIT) inserts for the SyncroFlo Pump Station. Simply disconnect power from the control panel. Unplug the power and communication cable from the OIT. Remove the four nuts from the back of the OIT to lift it from the panel.
Remove the existing inserts by sliding them out from the bottom and right side of the unit.
The order for the inserts are from left to right, green/yellow, blue, and red. Then the thin green insert goes in the slot on the right side.
Doug Pine
Service Dept.
